This image shows the interfacial orbital ordering found in the spinel-layered interface.
(Photo source: DOI number: 10.1038/s41893-020-00660-9)
The promotion of electric cars has dramatically increased the demand for lithium-ion batteries. However, cobalt and nickel, the main cathode materials for the batteries, are not abundant. If the consumption continues, it will inevitably elevate the costs in the long run, so scientists have been actively developing alternative materials. A joint research team co-led by a scientist from City University of Hong Kong (CityU) has developed a much more stable, manganese-based cathode material.
The new material has higher capacity and is more durable than the existing cobalt and nickel cathode materials – 90% of capacity is retained even when the number of charging-recharging cycles doubled. Their findings shed lights on developing low cost and high efficiency manganese-based cathode materials for lithium-ion batteries.
The research team was co-led by Dr Liu Qi, Assistant Professor in the Department of Physics (PHY) at CityU, together with scientists from Nanjing University of Science and Technology (NUST), and the Institute of Physics, Chinese Academy of Sciences (IOPCAS). Their findings have been published in the scientific journal Nature Sustainability, titled “LiMnO2 cathode stabilized by interfacial orbital ordering for sustainable lithium-ion batteries”.
Technology bottleneck of manganese-based cathode materials: low capacity retention
Lithium-ion batteries are now widely used in cell phones and electric cars. Most of the cathode materials contain cobalt and nickel, which are both not abundant and create pollution to the environment in the exploitation process. Therefore, scientists are searching for alternative cathode materials, for example, manganese (Mn).
Among the leading manganese-based candidates, LiMnO2 is cost-effective, more environmentally friendly with larger theoretical capacity. However, it suffers from poor stability during the charging-recharging cycle. Breaking of grains, rapid structural degradation and serious dissolution of manganese may happen. Severe capacity decay upon cycling is resulted and therefore shortens its durability, hindering the application of LiMnO2 in the commercialised lithium-ion batteries.
Jahn-Teller distortion needs to be suppressed
Dr Liu, an expert in developing cathode materials for lithium-ion batteries, pointed out that the structural instability of manganese-based materials is mainly caused by the Jahn-Teller distortion in their atomic structure. Upon discharging, the Mn-O bond in LiMnO2 will be elongated, which is called Jahn-Teller distortion. Since there is a long-range collinear orbital ordering of the electron orbits of the Mn3+ ions without disturbance, a strong cooperative Jahn–Teller distortion is resulted. Their atomic structures are easily distorted.
Dr Liu and his team tackled the problem by applying interfacial engineering in the atomic structure, which disturbs the long-range collinear orbital ordering and suppresses a large scale of Jahn–Teller distortion.
Structural stability enhanced by interfacial engineering
The team prepared the spinel–layered (heterostructured) LiMnO2 via in situ electrochemical conversion from spinel Mn3O4 nanowall arrays. It is found that the electron orbits are oriented almost perpendicular to each other between the spinel and layered boundaries, resulted in the interfacial orbital ordering. “This has caused a disturbance of the long-range collinear orbital ordering, therefore Jahn–Teller distortion is suppressed,” explained Dr Liu.
Their experiment results showed that Jahn–Teller distortion was effectively suppressed with this heterostructure design. The degrees of distortion of the layered and spinel phase was only 2.5% and 5.5% respectively, while layered LiMnO2 and spinel LiMnO2 showed much greater degrees of distortion of 18% and 16% respectively. This implies that the heterostructured LiMnO2 exhibited much higher structural stability. The team also found that the volume changes from the spinel and layered phases counteract with each other, leading to a minimal total volume change for the material. As a result, the material exhibited superior structural stability.
Long cycle life
“The capacity of the LiCoO2 cathode material currently applied in electronic products like smartphones is about 165mAh/g, while our LiMnO2 cathode material has already achieved a capacity as high as 254.3 mAh g?1, which is much higher,” Dr Liu elaborated. “It is difficult for commercial LiCoO2 to maintain 90% capacity even at 1,000 cycles. And our material has achieved high capacity retention of 90.4% after 2,000 cycles, demonstrating a long cycle life,” he added.
They are the first team to deploy interfacial orbital ordering to suppress the Jahn–Teller distortion. This novel method facilitated the development of sustainable Mn-rich cathode materials, in the hope of applying them in sustainable and commercialised energy storage devices. “We look forward to cost reduction in energy storage technology which can promote the energy structure in moving towards sustainability. Our material can potentially replace the currently commercialised cobalt materials for applications such as electronics and electric cars,” concluded Dr Liu.
Original Article: Technology breakthrough: doubling the charging-recharging cycle of lithium batteries
More from: City University of Hong Kong | Nanjing University of Science and Technology | Chinese Academy of Sciences | Sun Yat-Sen University | Argonne National Laboratory
The Latest Updates from Bing News & Google News
Go deeper with Bing News on:
Lithium-ion batteries
- Breakthrough in Sodium Battery Chemistry Promises Lower Costs
A new mass synthesis process for sodium-containing sulfides could make all-solid-state sodium batteries more affordable and safer than lithium-ion batteries.
- Why are lithium ion batteries a hazard? What to know after Columbus LIB fire spurs evacuation
A Columbus tractor trailer fire caused by lithium batteries on Thursday has us asking: Why do lithium batteries explode? And can you recycle them?
Go deeper with Google Headlines on:
Lithium-ion batteries
[google_news title=”” keyword=”lithium-ion batteries” num_posts=”5″ blurb_length=”0″ show_thumb=”left”]
Go deeper with Bing News on:
Manganese-based cathode
- Saline solution-based method efficiently recovers critical minerals from e-waste
A method developed at the Pacific Northwest National Laboratory selectively recovers manganese, magnesium, dysprosium, and neodymium from spent electronics.
- Critical minerals recovery from electronic waste
A nontoxic separation process recovers critical minerals from electronic scrap waste.
- Wildcat receives 100th patent for battery materials innovation and technology
Battery materials pioneer Wildcat Discovery Technologies today announced it received its 100th patent, reinforcing its industry-leading innovation and advancing its strategy for U.S.-based cathode ...
- Giyani Completes First Drawdown on its US$16 Million IDC Facility
Giyani has received the first drawdown of US$5.7m (ZAR109m) from its US$16m ZAR equivalent IDC Facility. The IDC has the ability to convert the outstanding amount extended under the IDC Facility into ...
- Electrolytic Manganese Dioxide (EMD) Market Charting a Course Future-Proofing Your Business for Market Changes
Report Ocean has unveiled a cutting-edge research report titled “Electrolytic Manganese Dioxide (EMD) Market” for the year 2024, delving into critical facets such as industry dimensions, market share ...
Go deeper with Google Headlines on:
Manganese-based cathode
[google_news title=”” keyword=”manganese-based cathode” num_posts=”5″ blurb_length=”0″ show_thumb=”left”]