MIT researchers have developed an ultrathin loudspeaker that can turn any rigid surface into a high-quality, active audio source. The straightforward fabrication process they introduced can enable the thin-film devices to be produced at scale. Image: Felice Frankel
MIT engineers have developed a paper-thin loudspeaker that can turn any surface into an active audio source.
This thin-film loudspeaker produces sound with minimal distortion while using a fraction of the energy required by a traditional loudspeaker. The hand-sized loudspeaker the team demonstrated, which weighs about as much as a dime, can generate high-quality sound no matter what surface the film is bonded to.
To achieve these properties, the researchers pioneered a deceptively simple fabrication technique, which requires only three basic steps and can be scaled up to produce ultrathin loudspeakers large enough to cover the inside of an automobile or to wallpaper a room.
Used this way, the thin-film loudspeaker could provide active noise cancellation in clamorous environments, such as an airplane cockpit, by generating sound of the same amplitude but opposite phase; the two sounds cancel each other out. The flexible device could also be used for immersive entertainment, perhaps by providing three-dimensional audio in a theater or theme park ride. And because it is lightweight and requires such a small amount of power to operate, the device is well-suited for applications on smart devices where battery life is limited.
“It feels remarkable to take what looks like a slender sheet of paper, attach two clips to it, plug it into the headphone port of your computer, and start hearing sounds emanating from it. It can be used anywhere. One just needs a smidgeon of electrical power to run it,” says Vladimir Bulovi?, the Fariborz Maseeh Chair in Emerging Technology, leader of the Organic and Nanostructured Electronics Laboratory (ONE Lab), director of MIT.nano, and senior author of the paper.
Bulovi? wrote the paper with lead author Jinchi Han, a ONE Lab postdoc, and co-senior author Jeffrey Lang, the Vitesse Professor of Electrical Engineering. The research is published today in IEEE Transactions of Industrial Electronics.
A new approach
A typical loudspeaker found in headphones or an audio system uses electric current inputs that pass through a coil of wire that generates a magnetic field, which moves a speaker membrane, that moves the air above it, that makes the sound we hear. By contrast, the new loudspeaker simplifies the speaker design by using a thin film of a shaped piezoelectric material that moves when voltage is applied over it, which moves the air above it and generates sound.
Most thin-film loudspeakers are designed to be freestanding because the film must bend freely to produce sound. Mounting these loudspeakers onto a surface would impede the vibration and hamper their ability to generate sound.
To overcome this problem, the MIT team rethought the design of a thin-film loudspeaker. Rather than having the entire material vibrate, their design relies on tiny domes on a thin layer of piezoelectric material which each vibrate individually. These domes, each only a few hair-widths across, are surrounded by spacer layers on the top and bottom of the film that protect them from the mounting surface while still enabling them to vibrate freely. The same spacer layers protect the domes from abrasion and impact during day-to-day handling, enhancing the loudspeaker’s durability.
To build the loudspeaker, the researchers used a laser to cut tiny holes into a thin sheet of PET, which is a type of lightweight plastic. They laminated the underside of that perforated PET layer with a very thin film (as thin as 8 microns) of piezoelectric material, called PVDF. Then they applied vacuum above the bonded sheets and a heat source, at 80 degrees Celsius, underneath them.
Because the PVDF layer is so thin, the pressure difference created by the vacuum and heat source caused it to bulge. The PVDF can’t force its way through the PET layer, so tiny domes protrude in areas where they aren’t blocked by PET. These protrusions self-align with the holes in the PET layer. The researchers then laminate the other side of the PVDF with another PET layer to act as a spacer between the domes and the bonding surface.
“This is a very simple, straightforward process. It would allow us to produce these loudspeakers in a high-throughput fashion if we integrate it with a roll-to-roll process in the future. That means it could be fabricated in large amounts, like wallpaper to cover walls, cars, or aircraft interiors,” Han says.
High quality, low power
The domes are 15 microns in height, about one-sixth the thickness of a human hair, and they only move up and down about half a micron when they vibrate. Each dome is a single sound-generation unit, so it takes thousands of these tiny domes vibrating together to produce audible sound.
An added benefit of the team’s simple fabrication process is its tunability — the researchers can change the size of the holes in the PET to control the size of the domes. Domes with a larger radius displace more air and produce more sound, but larger domes also have lower resonance frequency. Resonance frequency is the frequency at which the device operates most efficiently, and lower resonance frequency leads to audio distortion.
Once the researchers perfected the fabrication technique, they tested several different dome sizes and piezoelectric layer thicknesses to arrive at an optimal combination.
They tested their thin-film loudspeaker by mounting it to a wall 30 centimeters from a microphone to measure the sound pressure level, recorded in decibels. When 25 volts of electricity were passed through the device at 1 kilohertz (a rate of 1,000 cycles per second), the speaker produced high-quality sound at conversational levels of 66 decibels. At 10 kilohertz, the sound pressure level increased to 86 decibels, about the same volume level as city traffic.
The energy-efficient device only requires about 100 milliwatts of power per square meter of speaker area. By contrast, an average home speaker might consume more than 1 watt of power to generate similar sound pressure at a comparable distance.
Because the tiny domes are vibrating, rather than the entire film, the loudspeaker has a high enough resonance frequency that it can be used effectively for ultrasound applications, like imaging, Han explains. Ultrasound imaging uses very high frequency sound waves to produce images, and higher frequencies yield better image resolution.
The device could also use ultrasound to detect where a human is standing in a room, just like bats do using echolocation, and then shape the sound waves to follow the person as they move, Bulovi? says. If the vibrating domes of the thin film are covered with a reflective surface, they could be used to create patterns of light for future display technologies. If immersed in a liquid, the vibrating membranes could provide a novel method of stirring chemicals, enabling chemical processing techniques that could use less energy than large batch processing methods.
“We have the ability to precisely generate mechanical motion of air by activating a physical surface that is scalable. The options of how to use this technology are limitless,” Bulovi? says.
“I think this is a very creative approach to making this class of ultra-thin speakers,” says Ioannis (John) Kymissis, Kenneth Brayer Professor of Electrical Engineering and Chair of the Department of Electrical Engineering at Columbia University, who was not involved with this research. “The strategy of doming the film stack using photolithographically patterned templates is quite unique and likely to lead to a range of new applications in speakers and microphones.”
Original Article: Researchers develop a paper-thin loudspeaker
More from: Massachusetts Institute of Technology
The Latest Updates from Bing News & Google News
Go deeper with Bing News on:
Paper-thin loudspeaker
- Hands on: iPad Pro 13-inch (2024): The impossibly thin king of iPads – and maybe all tablets
Imagine a 13-inch iPad Pro that's a quarter-pound lighter than the last model, thinner than any gadget Apple has made before, packing completely new display technology, and powered by brand-new Apple ...
- Researchers Develop 'Hair-Thin' Fabric that Effectively Suppresses Sound
For instance, one could use such a fabric to make dividers in open workspaces or thin fabric walls that prevent sound from ... and senior author of a paper on the fabric. The study’s lead author is ...
- This sound-suppressing silk can create quiet spaces
Researchers developed a silk fabric, which is barely thicker than a human hair, that can suppress unwanted noise and reduce noise transmission in a large room.
- Transcript: Read Biden’s Remarks at a Holocaust Remembrance Ceremony
President Biden delivered these remarks on Tuesday at the Capitol for the U.S. Holocaust Memorial Museum’s Days of Remembrance. Thank you, Stu, for that introduction, for your l ...
- In Speech, Biden Describes Surge of Antisemitism in U.S.
President Biden’s speech at a Holocaust remembrance ceremony came during weeks of protests on U.S. college campuses against Israel’s war in Gaza. He emphasized Americans’ responsibility to combat ...
Go deeper with Google Headlines on:
Paper-thin loudspeaker
[google_news title=”” keyword=”paper-thin loudspeaker” num_posts=”5″ blurb_length=”0″ show_thumb=”left”]
Go deeper with Bing News on:
Thin-film loudspeakers
- With Deepfake Avatars And Tokens, AI Transforms Weed, Fintech And Real Estate Markets, CEO Explains How
Darius Bruner, CEO of 8blockchainfund, manages a turnkey special purpose vehicle (SPV) fund that uses AI technology to streamline business capital formation. In a detailed discussion, Bruner describes ...
- 'Germophobe' Trump is terrified at the thought of prison: ex-aide
For all his bluster, former President Donald Trump is genuinely terrified of spending a night in jail for contempt of court because of his germophobia, his ex-aide Sarah Matthews told CNN's Jim Acosta ...
- The 5 best HP laptops for working from home in 2024
HP has a lot of great laptops, so if you're looking to snag yourself one to work from home, come check out our favorite picks.
- This SanDisk 8TB SSD Is Perfect For Desk Jockeys And Home Workers
If you need lots of space for all that content you are creating, this massive 8TB SanDisk Desk Drive offers a lot of fast SSD storage at a sensible price.
- Buy Rating Affirmed for Knowles Corporation on Revenue Rebound and Strategic Acquisitions
Knowles (KN – Research Report), the Technology sector company, was revisited by a Wall Street analyst yesterday. Analyst Tristan Gerra ...
Go deeper with Google Headlines on:
Thin-film loudspeakers
[google_news title=”” keyword=”thin-film loudspeakers” num_posts=”5″ blurb_length=”0″ show_thumb=”left”]