A stencil-printed paper battery designed to spell out the name of our research institute (“Empa”). The battery can run low-power electronics such as the liquid crystal display (LCD) alarm clock connected to the battery
Just add a drop of water
The battery, devised by Gustav Nyström and his team, is made of at least one cell measuring one centimeter squared and consisting of three inks printed onto a rectangular strip of paper. Salt, in this case simply sodium chloride or table salt, is dispersed throughout the strip of paper and one of its shorter ends has been dipped in wax. An ink containing graphite flakes, which acts as the positive end of the battery (the cathode), is printed onto one of the flat sides of the paper while an ink containing zinc powder, which acts as the negative end of the battery (the anode), is printed onto the reverse side of the paper. Yet another ink containing graphite flakes and carbon black is printed on both sides of the paper, on top of the other two inks. This ink makes up the current collectors connecting the positive and negative ends of the battery to two wires, which are located at the wax-dipped end of the paper.
When a small amount of water is added, the salts within the paper dissolve and charged ions are released, thus making the electrolyte ionically conductive. These ions activate the battery by dispersing through the paper, resulting in zinc in the ink at the anode being oxidized thereby releasing electrons. By closing the (external) circuit these electrons can then be transferred from the zinc-containing anode – via the graphite- and carbon black-containing ink, the wires and the device – to the graphite cathode where they are transferred to – and hence reduce – oxygen from ambient air. These redox reactions (reduction and oxidation) thus generate an electrical current that can be used to power an external electrical device.
Proof of concept: a sustainable energy source for low-power electronics
To demonstrate the ability of their battery to run low-power electronics, Nyström’s team combined two cells into one battery to increase the operating voltage and used it to power an alarm clock with a liquid crystal display. Analysis of the performance of a one-cell battery revealed that after two drops of water were added, the battery activated within 20 seconds and, when not connected to an energy-consuming device, reached a stable voltage of 1.2 volts. The voltage of a standard AA alkaline battery is 1.5 volts.
After one hour, the one-cell battery’s performance decreased significantly due to the paper drying. However, after the researchers added two extra drops of water, the battery maintained a stable operating voltage of 0.5 volts for more than one additional hour.
The researchers propose that the biodegradability of paper and zinc could enable their battery to minimize the environmental impact of disposable, low-power electronics. “What’s special about our new battery is that, in contrast many metal air batteries using a metal foil that is gradually consumed as the battery is depleted, our design allows to add only the amount of zinc to the ink that is actually needed for the specific application”, says Nyström. Metal foils were more difficult to control and not always fully consumed leading to a waste of materials. So the more zinc the ink contains, the longer the battery is able to operate.
A more critical point of the battery’s current design with water activation, Nyström adds, is the time it takes for the battery to dry out. “But I am sure this can be engineered differently to get around this problem.” For environmental sensing applications at a certain humidity or in wet environments, however, the drying of the paper would not be an issue.
Two complementary technologies
Previously, Nyström’s team had already developed a paper-based degradable super capacitor that could be charged and discharged thousands of times without losing efficiency. Compared to batteries of the same weight, supercapacitors have an energy density that is around 10 times lower – while at the same time having a power density that is around ten to one hundred times greater. Supercapacitors can therefore be charged and discharged much faster. They can also withstand many more charge and discharge cycles. “So the two devices are actually complementary”, says Nyström. The idea behind the new water-activated battery was to be able to manufacture devices that are fully charged and that only release this energy after the triggering of a stimulus, in this case simply a drop of water.
Original Article: A paper battery with water switch
The Latest Updates from Bing News & Google News
Go deeper with Bing News on:
- Electrolyte solution reduces Li-ion battery recharging time while capacity remains at low temperatures
A team of chemists and engineers affiliated with several institutions has found an electrolyte solution that can be used to reduce the recharging time of lithium-ion batteries while allowing battery ...
- OnePlus Watch 2 hands on: Big battery life for comeback kid
The “heavy use” estimate including having the co-processor turned off and using third-party watch faces is still 48 hours – and we’d expect that most people will get three days out of the OnePlus ...
- New battery tech could finally improve EV performance in extreme weather
A team of researchers led by Xiulin Fan, a professor at China's Zhejiang University, has just published a paper in Nature magazine ... If that happens, it is sure to improve battery stamina and reduce ...
- BASF battery project delayed because of environmental concerns
Robert Baylis, principal at the battery supply chain consulting firm Carding Mill ... permissive regulations regarding sulfate emissions because of the country’s paper and pulp industry, which also ...
- ReMarkable 2 tablet review: Paper and pen experience
The reMarkable 2 tablet is unique: it offers a paper-like feel for writing and drawing and aims to give users the charm and utility of paper writing, scribbling and doodling that are hard to come by ...
Go deeper with Google Headlines on:
[google_news title=”” keyword=”paper battery” num_posts=”5″ blurb_length=”0″ show_thumb=”left”]
Go deeper with Bing News on:
- Here’s How Much It Costs To Refill A Hydrogen-powered Honda CR-V
as its battery will cost anywhere between $2.22 to $7.43 to recharge, depending on which city you reside in. The Honda CR-V e:FCEV is a completely emissions-free crossover, as the only byproduct from ...
- Mini water coolers: 5 portable picks to help you stay cool in scorching summers
With the mercury levels already soaring, it's time to stay prepared for the scorching summer heat that is just about to knock in. With the shooting temperatures, staying hydrated and keeping your home ...
- Cater Battery Energy Storage Project
Tesla Megapack batteries were activated at the City's Cater Water Treatment Plant on December 7, 2023. These battery systems provide power backup to the City’s water treatment plant, while they also ...
- The 6 Best Water-Leak Detectors for Protecting Your Home
These simple, relatively inexpensive devices can help prevent flooding—and save you a giant hassle and expense.
- These Editor-Approved Water-Leak Detectors Can Help Prevent a Flood in Your Home
They monitor water usage and, if there’s a sudden drop in flow, automatically shut down the supply (more on that below). Battery-operated water-leak detectors are generally more common (and less ...
Go deeper with Google Headlines on:
[google_news title=”” keyword=”water-activated battery” num_posts=”5″ blurb_length=”0″ show_thumb=”left”]