Experimental setup of dual-membrane-structured PSA RFB.
CREDIT: Imperial College London
A new approach to battery design could provide the key to low-cost, long-term energy storage, according to Imperial College London researchers.
The team of engineers and chemists have created a polysulfide-air redox flow battery (PSA RFB) with not one, but two membranes. The dual membrane design overcomes the main problems with this type of large-scale battery, opening up its potential to store excess energy from, for example, renewable sources such as wind and solar. The research is published in Nature Communications.
In redox flow batteries, energy is stored in liquid electrolytes which flow through the cells during charge and discharge, enabled through chemical reactions. The amount of energy stored is determined by the volume of the electrolyte, making the design potentially easy to scale up. However, the electrolyte used in conventional redox flow batteries – vanadium – is expensive and primarily sourced from either China or Russia.
The Imperial team, led by Professors Nigel Brandon and Anthony Kucernak, have been working on alternatives that use lower cost materials which are widely available. Their approach uses a liquid as one electrolyte and a gas as the other – in this case polysulfide (sulphur dissolved in an alkaline solution) and air. However, the performance of polysulfide-air batteries is limited because no membrane could fully enable the chemical reactions to take place while still preventing polysulfide crossing over into the other part of the cell.
Dr Mengzheng Ouyang, from Imperial’s Department of Earth Science and Engineering, explained: “If the polysulfide crosses over into the air side, then you lose material from one side, which reduces the reaction taking place there and inhibits the activity of the catalyst on the other. This reduces the performance of the battery – so it was a problem we needed to solve.”
The alternative devised by the researchers was to use two membranes to separate the polysulfide and the air, with a solution of sodium hydroxide between them. The advantage of the design is that all materials, including the membranes, are relatively cheap and widely available, and that the design provides far more choice in the materials that can be used.
When compared with the best results obtained to date from a polysulfide-air redox flow battery, the new design was able to provide significantly more power, up to 5.8 milliwatts per centimetre squared.
As cost is a critical factor for long-term and large-scale storage, the team also carried out a cost analysis. They calculated the energy cost – the price of the storage materials in relation to the amount of energy stored – to be around $2.5 per kilowatt hour.
The power cost – the rate of charge and discharge achieved in relation to the price of the membranes and catalysts in the cell – was found to be around $1600 per kilowatt. This is currently higher than would be feasible for large-scale energy storage, but the team believe further improvements are readily achievable.
Professor Nigel Brandon, who is also Dean of the Faculty of Engineering, said: “Our dual-membrane approach is very exciting as it opens up many new possibilities, for both this and other batteries. To make this cost effective for large-scale storage, a relatively modest improvement in performance would be required, which could be achieved by changes to the catalyst to increase its activity or by further improvements in the membranes used.”
Work in this area is already underway within the team, through the catalyst expertise of Professor Anthony Kucernak, from the Department of Chemistry, and research into membrane technology by Dr Qilei Song from the Department of Chemical Engineering.
The spin-out company RFC Power Ltd, established to develop long-duration storage of renewable energy based on the team’s research, is set to commercialise this new design should the improvements be made.
CEO of RFC Power Ltd, Tim Von Werne, said: “There is a pressing need for new ways to store renewable energy over days, weeks or even months at a reasonable cost. This research shows a way to make that possible through improved performance and low-cost materials.”
Original Article: Dual membrane offers hope for long-term energy storage
More from: Imperial College London
The Latest Updates from Bing News & Google News
Go deeper with Bing News on:
Polysulfide-air redox flow battery
- Dual-membrane battery could deliver grid scale storage
Although they are significantly less power dense than lithium-ion batteries, redox flow batteries are viewed by many as better suited to large-scale energy storage due to their long lifecycles and ...
- Dual-membrane battery offers grid scale storage
Although they are significantly less power dense than lithium-ion batteries, redox flow batteries are viewed by many as better suited to large-scale energy storage due to their long lifecycles and ...
- Dual-membrane battery has potential to unlock long-term energy storage from renewables
A dual-membrane approach to battery design could facilitate low-cost, long-term energy storage, according to Imperial College London researchers. The team of engineers and chemists have created a ...
- A new type of battery provides low-cost, long-term energy storage
The Imperial team of engineers and chemists developed a polysulfide-air redox flow battery (PSA RFB) with two membranes. This dual membrane design provides a workaround for some of the issues with ...
- Innovative Dual-Membrane Design Provides More Flexibility for Redox Flow Battery Designs
Image Credit: Imperial College London. The engineers and chemists have developed a polysulfide-air redox flow battery (PSA RFB) with two membranes instead of one. The dual membrane design solves the ...
Go deeper with Google Headlines on:
Polysulfide-air redox flow battery
Go deeper with Bing News on:
Long-term energy storage
- Fluence Energy, Inc. Reports Second Quarter 2022 Results
Fluence Energy, Inc. (Nasdaq: FLNC) (“Fluence” or the “Company”), a leading global pure-play provider of energy storage pr ...
- Tens of thousands of acres needed for solar fields to meet Consumers Energy climate goals
accelerate battery energy storage development, and rollout massive amounts of solar fields across Michigan. The plan is part of a proposed settlement with a stakeholder coalition negotiated as part of ...
- Univar Solutions to Significantly Increase On-Site Renewable Energy Capacity, through Partnership with Sustainable Solutions Provider Motive Energy
Company to install 1020 kilowatt (kW) solar panels and an energy storage system (ESS), with total energy capacity of 375kW / 753 kilowatt hour (kWh), at its City of Commerce, California location, ...
- Vodafone signs 10-year deal for three new solar farms in the UK securing clean energy and supporting its net zero ambitions
Vodafone has signed a 10-year agreement[1] for power generated from three new solar farms in Lincolnshire, Worcestershire and Nottinghamshire, securing clean energy and supporting its ambition to ...
- Huawei unveils new all-scenario smart PV and energy storage solutions at Intersolar Europe
Long-term Investment to Enable Continuous Innovation Focusing ... AI and cloud technologies to promote the smart development of the PV and energy storage industries. As the president of the ENSTO-E ...