Research by UNSW academics shows that special treatment of liquid resin used in 3D printing can cause the material to mend itself if it becomes damaged

UNSW engineers have demonstrated a way to help 3D printed plastic heal itself at room temperature using only lights.

Professor Cyrille Boyer and his team, Dr Nathaniel Corrigan and Mr Michael Zhang, in the UNSW School of Chemical Engineering have shown that the addition of “special powder” to the liquid resin used in the printing process can later assist with making quick and easy repairs should the material break.

This can be done very simply by shining standard LED lights on the printed plastic for around one hour which causes a chemical reaction and fusion of the two broken pieces.

The entire process actually makes the repaired plastic even stronger than it was before it was damaged, and it is hoped that further development and commercialisation of the technique will help to reduce chemical waste in the future.

That is because broken plastic parts would not need to be discarded, or even recycled, and could be mended simply even when remaining embedded in a component including many other materials.

The results of the team’s research have now been published in the journal Angewandte Chemie International Edition.

Reducing plastic waste

“In many places where you use a polymer material, you can use this technology. So, if a component fails, you can repair the material without having to throw it away,” said Dr Corrigan.

“There is an obvious environmental benefit because you’re not having to re-synthesize a brand-new material every time it gets broken. We are increasing the lifespan of these materials, which is going to reduce plastic waste.”

The powdered additive the UNSW team use is a trithiocarbonate, known as a reversible addition fragmentation chain transfer (RAFT) agent which was originally developed by CSIRO. The RAFT agent enables rearrangement of the nanoscopic network of elements that make up the material and allows the broken pieces to be fused.

This occurs within approximately 30 minutes when UV LED lights are shone directly onto the broken plastic, with full healing taking place after roughly one hour.

Original Article: Self-healing 3D printed plastic can repair itself… using only light

More from: University of New South Wales