The cooling tower of MIT’s nuclear plant has demonstrated the effectiveness of the new water recovery system. The right side of the tower has the new system installed, eliminating its plume of vapor, while the untreated left side continues to produce a steady vapor stream.
Image: Courtesy of the researchers
System could reclaim pure water from power plant cooling towers; at-scale prototypes tested on MIT facilities have proven effective
About two-fifths of all the water that gets withdrawn from lakes, rivers, and wells in the U.S. is used not for agriculture, drinking, or sanitation, but to cool the power plants that provide electricity from fossil fuels or nuclear power. Over 65 percent of these plants use evaporative cooling, leading to huge white plumes that billow from their cooling towers, which can be a nuisance and, in some cases, even contribute to dangerous driving conditions.
Now, a small company based on technology recently developed at MIT by the Varanasi Research Group is hoping to reduce both the water needs at these plants and the resultant plumes — and to potentially help alleviate water shortages in areas where power plants put pressure on local water systems.
The technology is surprisingly simple in principle, but developing it to the point where it can now be tested at full scale on industrial plants was a more complex proposition. That required the real-world experience that the company’s founders gained from installing prototype systems, first on MIT’s natural-gas-powered cogeneration plant and then on MIT’s nuclear research reactor.
In these demanding tests, which involved exposure to not only the heat and vibrations of a working industrial plant but also the rigors of New England winters, the system proved its effectiveness at both eliminating the vapor plume and recapturing water. And, it purified the water in the process, so that it was 100 times cleaner than the incoming cooling water. The system is now being prepared for full-scale tests in a commercial power plant and in a chemical processing plant.
“Campus as a living laboratory”
The technology was originally envisioned by professor of mechanical engineering Kripa Varanasi to develop efficient water-recovery systems by capturing water droplets from both natural fog and plumes from power plant cooling towers. The project began as part of doctoral thesis research of Maher Damak PhD ’18, with funding from the MIT Tata Center for Technology and Design, to improve the efficiency of fog-harvesting systems like the ones used in some arid coastal regions as a source of potable water. Those systems, which generally consist of plastic or metal mesh hung vertically in the path of fogbanks, are extremely inefficient, capturing only about 1 to 3 percent of the water droplets that pass through them.
Varanasi and Damak found that vapor collection could be made much more efficient by first zapping the tiny droplets of water with a beam of electrically charged particles, or ions, to give each droplet a slight electric charge. Then, the stream of droplets passes through a wire mesh, like a window screen, that has an opposite electrical charge. This causes the droplets to be strongly attracted to the mesh, where they fall away due to gravity and can be collected in trays placed below the mesh.
Lab tests showed the concept worked, and the researchers, joined by Karim Khalil PhD ’18, won the MIT $100K Entrepreneurship Competition in 2018 for the basic concept. The nascent company, which they called Infinite Cooling, with Damak as CEO, Khalil as CTO, and Varanasi as chairperson, immediately went to work setting up a test installation on one of the cooling towers of MIT’s natural-gas-powered Central Utility Plant, with funding from the MIT Office of Sustainability. After experimenting with various configurations, they were able to show that the system could indeed eliminate the plume and produce water of high purity.
Professor Jacopo Buongiorno in the Department of Nuclear Science and Engineering immediately spotted a good opportunity for collaboration, offering the use of MIT’s Nuclear Reactor Laboratory research facility for further testing of the system with the help of NRL engineer Ed Block. With its 24/7 operation and its higher-temperature vapor emissions, the plant would provide a more stringent real-world test of the system, as well as proving its effectiveness in an actual operating reactor licensed by the Nuclear Regulatory Commission, an important step in “de-risking” the technology so that electric utilities could feel confident in adopting the system.
After the system was installed above one of the plant’s four cooling towers, testing showed that the water being collected was more than 100 times cleaner than the feedwater coming into the cooling system. It also proved that the installation — which, unlike the earlier version, had its mesh screens mounted vertically, parallel to the vapor stream — had no effect at all on the operation of the plant. Video of the tests dramatically illustrates how as soon as the power is switched on to the collecting mesh, the white plume of vapor immediately disappears completely.
The high temperature and volume of the vapor plume from the reactor’s cooling towers represented “kind of a worst-case scenario in terms of plumes,” Damak says, “so if we can capture that, we can basically capture anything.”
Working with MIT’s Nuclear Reactor Laboratory, Varanasi says, “has been quite an important step because it helped us to test it at scale. … It really both validated the water quality and the performance of the system.” The process, he says, “shows the importance of using the campus as a living laboratory. It allows us to do these kinds of experiments at scale, and also showed the ability to sustainably reduce the water footprint of the campus.”
Power plant plumes are often considered an eyesore and can lead to local opposition to new power plants because of the potential for obscured views, and even potential traffic hazards when the obscuring plumes blow across roadways. “The ability to eliminate the plumes could be an important benefit, allowing plants to be sited in locations that might otherwise be restricted,” Buongiorno says. At the same time, the system could eliminate a significant amount of water used by the plants and then lost to the sky, potentially alleviating pressure on local water systems, which could be especially helpful in arid regions.
The system is essentially a distillation process, and the pure water it produces could go into power plant boilers — which are separate from the cooling system — that require high-purity water. That might reduce the need for both fresh water and purification systems for the boilers.
What’s more, in many arid coastal areas power plants are cooled directly with seawater. This system would essentially add a water desalination capability to the plant, at a fraction of the cost of building a new standalone desalination plant, and at an even smaller fraction of its operating costs since the heat would essentially be provided for free.
Contamination of water is typically measured by testing its electrical conductivity, which increases with the amount of salts and other contaminants it contains. Water used in power plant cooling systems typically measures 3,000 microsiemens per centimeter, Khalil explains, while the water supply in the City of Cambridge is typically around 500 or 600 microsiemens per centimeter. The water captured by this system, he says, typically measures below 50 microsiemens per centimeter.
Thanks to the validation provided by the testing on MIT’s plants, the company has now been able to secure arrangements for its first two installations on operating commercial plants, which should begin later this year. One is a 900-megawatt power plant where the system’s clean water production will be a major advantage, and the other is at a chemical manufacturing plant in the Midwest.
In many locations power plants have to pay for the water they use for cooling, Varanasi says, and the new system is expected to reduce the need for water by up to 20 percent. For a typical power plant, that alone could account for about a million dollars saved in water costs per year, he says.
“Innovation has been a hallmark of the U.S. commercial industry for more than six decades,” says Maria G. Korsnick, president and CEO of the Nuclear Energy Institute, who was not involved in the research. “As the changing climate impacts every aspect of life, including global water supplies, companies across the supply chain are innovating for solutions. The testing of this innovative technology at MIT provides a valuable basis for its consideration in commercial applications.”
Original Article: Vapor-collection technology saves water while clearing the air
More from: Massachusetts Institute of Technology
The Latest Updates from Bing News & Google News
Go deeper with Bing News on:
Water recovery system
- Global Water Treatment Systems Market Research Report 2021 - Impact of COVID-19 on the Market
Pages Report] Check for Discount on Global Water Treatment Systems Market Research Report 2021 - Impact of COVID-19 on the Market report by Maia Research.
- Why Recovery Is Essential to Any Workout Routine—and How to Do It Right
In many ways, post-workout recovery and full recovery days are just as important as those intense workout days. In fact, taking proper recovery can actually help make you a better athlete and ...
- Hydrogen Optimized achieves ‘world’s first’ for hydrogen production through water electrolysis
Hydrogen Optimized has said today (Dec 8) that it will boost hydrogen production having achieved a “world-first” for water electrolysis units by ramping from 0 to 50,000 amperes in less than 10 ...
- Judge denies all objections to Flint water lawsuit settlement. Here’s a breakdown.
Last month, a federal judge gave the $626.25-million Flint water lawsuit final approval, and denied all objections made against it. The ...
- ‘Complicated road to recovery’: New Biscayne Bay board targets septic-to-sewer conversion
Miami-Dade’s new Biscayne Bay Watershed Management Advisory Board met for the first time this week to help Mayor Daniella Levine Cava and commissioners figure out what to do to save the county’s crown ...
Go deeper with Google Headlines on:
Water recovery system
Go deeper with Bing News on:
- Leveraging Li-Ion Energy Storage to Create a Low-Emissions Offshore Drilling Rig
Lithium-ion batteries are being used for supplying power during peak load times and serve as back-up to prevent blackout situations and provide power to the thrusters in the unlikely event of loss of ...
- 5 incredible new discoveries about our next home, the Red Planet Mars
NASA's rovers are scouring the surface of the Red Planet for any information that will assist in getting humans living on Mars.
- Best Apple Watch bands 2021: our pick of the great Apple wearable straps
If you're keen to express your nationality on your wrist, the International Collection Sport Loop is ... The use of a physical vapor deposition layer means it has an extra distinctive finish ...
- Global E-cigarette and Vaping Market Report to Cover Industrial Chain Analysis, Manufacturing Cost Structure, Process Analysis
New York, US, Market Research Store published a business study on the Global E-cigarette and Vaping market is a complete analysisof overall market growth dynamics. The report offers users accurate ...
- BoomBaptist and the Art of Crafty Self Promotion Schemes
"He's casting a wide net, bringing in people who'd never buy instrumental hip-hop, and I'm not sure everybody's ready." Indeed, despite the numerous Austinites who've learned the BoomBaptist name ...